(From: Dave Moore (firstname.lastname@example.org).
|NotTaR of Television Sets : Dave's complete procedure for repair of ..
1994-2007, Samuel M. Goldwasser. All Rights Reserved. Reproduction of this document in whole or in part is permitted if both of the following conditions are satisfied: 1. This notice is included in its entirety at the beginning. 2. There is no charge except to cover the costs of copying.
I may be contacted via the Sci.Electronics.Repair FAQ (www.repairfaq.org) Email Links Page.
<< Arcing from flyback or vi.. |
| Arcing at spark gaps and .. >>
First I clean the afflicted area with Electromotive spray from Autozone. It's
for cleaning alternators. On Z-line I remove the focus control and wash with
the alternator cleaner and a tooth brush until all dirt and carbon deposits
are removed. Then I take an xacto knife and carve out the carbonized hole
where the arcing broke through. Then take your soldering iron and close the
hole by melting adjacent plastic into it. (clean any solder off your iron with
solder-wick first). Then cut some plastic off of some other part off the
flyback where it wont be needed and use this to plastic weld (with your iron)
a hump of a patch into and over the arc hole. Smooth and seal with iron. Next
apply as thick a layer of silicone rubber as you can and let dry overnight.