This means you have lost the luminance input to the chroma decoder or final
video chip. A failure of the brightness limiter may result in similar
|NotTaR of Television Sets : Saturated color but almost no brightness
1994-2007, Samuel M. Goldwasser. All Rights Reserved. Reproduction of this document in whole or in part is permitted if both of the following conditions are satisfied: 1. This notice is included in its entirety at the beginning. 2. There is no charge except to cover the costs of copying.
I may be contacted via the Sci.Electronics.Repair FAQ (www.repairfaq.org) Email Links Page.
<< No color - black and whit.. |
| Brightness control has no.. >>
A few common causes are:
- Check the service switch (if any). Its contacts may be dirty and moving it
back and forth a few times or using contact cleaner may be all that is
- Check for open high value resistors around the chroma decoder IC.
- Check for open high value resistors in the brightness limiter circuit.
With a scope and schematic (or even just a pinout for the chip), you should be
able to trace the luminance signal to see where it is getting lost.
This is also NOT a picture tube problem. :-)
(From: John Mehrtens (firstname.lastname@example.org).)
I have had several TVs and monitors where the delay line in the luminance
circuitry has failed. Usually it's made out of glass, and inherently is
fragile. Sometimes whacking the monitor would make it come back, leading
to the thought of connectoritis or a cold solder joint -- where in fact it
was the delay line (long rectangular unit with two to four leads).
Replacing the delay line was the solution, but to check it first it'd be a
good idea to look for 'in' and 'out' on the line and short the pins. The
picture may be shifted, colours may not line up, but it'll tell you that
it's the delay line if the picture comes back at all. It's better than
looking at a saturated picture with no luminance! :)
<<No color - black and whit.. |
| Brightness control has no..>>